ISO IEC Amd Amendment to support lifecycle state, ISO IEC Conformity assessment Supplier's declaration of conformity Part General requirements (ISO IEC, corrected version), ISO Geotechnical investigation and testing Laboratory testing of soil, ISO IEC Information technology Data interchange on mm optical disk cartridges of type WORM (Write Once Read Many) using irreversible effects Capacity, Gbytes per cartridge, ISO Implants for surgery Metallic skeletal pins and wires, ISO Geotechnical investigation and testing Geothermal testing Determination of thermal conductivity of soil and rock using a borehole heat exchanger (ISO), ISO Intelligent transport systems (ITS) Nomadic device service platform for micro mobility, ISO ISO metric trapezoidal screw threads General plan, ISO IEC Information technology OpSystems Interconnection Common management information protocol Protocol Implementation Conformance Statement (PICS) proforma, ISO IEC Information technology UPnP device architecture Part Low Power Device Control Protocol Low Power Proxy Service. Click this ISO 21927-3:2021-Smoke and heat control systems for extra details.
ISO Packaging Steel drums Part Non removable head (tight head) drums with a minimum total capacity of l,, l and l (ISO), ISO Pneumatic fluid power Connections Ports and stud ends, ISO Road vehicles Vehicle to Grid Communication Interface, ISO PRF TR Safety requirements for lifts (elevators), ISO Milk and milk products Quality control in microbiological laboratories, ISO Non calibrated round steel link lifting chain and chain slings Use and maintenance, ISO Plastics Acrylonitrile styrene acrylate (ASA), acrylonitrile (ethylene propylene diene) styrene (AEPDS) and acrylonitrile (chlorinated polyethylene) styrene (ACS) moulding and extrusion materials, ISO Milk products Enumeration of presumptive Lactobacillus acidophilus on a selective medium Colony count technique at degrees C, ISO Metallic powders, excluding powders for hardmetals Determination of dimensional changes associated with compacting and sintering, ISO Medical devices Quality management systems Requirements for regulatory purposes. Follow this ISO 24117:2020-Tableware, giftware, jewellery and luminaries, made of glass Glass clarity Classification and test method for further information.
ISO Small bore connectors for liquids and gases in healthcare applications, ISO Truck and bus tyres and rims (metric series), ISO Spices, condiments and herbs Determination of volatile oil content (hydrodistillation method), ISO Textiles Tensile properties of fabrics Part Determination of maximum force using the grab method (ISO), ISO Sensory analysis Methodology General guidance for conducting hedonic tests with consumers in a controlled area (ISO), ISO Wrought aluminium and aluminium alloys Cold drawn rods bars, tubes and wires, ISO Ships and marine technology Single point mooring arrangements for conventional tankers, ISO Textiles Natural fibres Generic names and definitions (ISO), ISO TR Essential oils General guidance on the determination of flashpoint, ISO Safety of machinery Evaluation of the emission of airborne hazardous substances. Check out this ISO 6363-1:2012-Wrought aluminium and aluminium alloys Cold-drawn rods/bars, tubes and wires for good measure.